Kim, Ryan Jin Young

With rapid progress in a power conversion efficiency (PCE) to reach 25%, metal halide perovskite-based solar cells became a game-changer in a photovoltaic performance race. Triggered by the development of the solid-state perovskite solar cell in 2012, intense follow-up research works on structure design, materials chemistry, process engineering, and device physics have contributed to the revolutionary evolution of the solid-state perovskite solar cell to be a strong candidate for a next-generati

Maximizing the power conversion efficiency (PCE) of perovskite/silicon tandem solar cells that can exceed the Shockley-Queisser single-cell limit requires a high-performing, stable perovskite top cell with a wide bandgap. We developed a stable perovskite solar cell with a bandgap of ~1.7 electron volts that retained more than 80% of its initial PCE of 20.7% after 1000 hours of continuous illumination. Anion engineering of phenethylammonium-based two-dimensional (2D) additives was critical for co

NiO is a wide band gap p-type oxide semiconductor and has potential for applications in solar energy conversion as a hole-transporting layer (HTL). It also has good optical transparency and high chemical stability, and the capability of aligning the band edges to the perovskite (CH3NH3PbI3) layers. Ultra-thin and un-doped NiO films with much less absorption loss were prepared by atomic layer deposition (ALD) with highly precise control over thickness without any pinholes. Thin enough (5-7.5 nm i

We believe that the technique described herein can be further developed for PoGNP-utilized antiviral protection as well as metal nanoparticle-based therapy to treat viral infection. Additionally, facile detection of IAV can be achieved by developing PoGNP as a multiplatform for detection of the virus.

As energy demand grows globally, the energy management system (EMS) is becoming increasingly important. Energy prediction is an essential component in the first step to create a management plan in EMS. Conventional energy prediction models focus on prediction performance, but in order to build an efficient system, it is necessary to predict energy demand according to various conditions. In this paper, we propose a method to predict energy demand in various situations using a deep learning model

Histotroph is required for survival and development of ovine conceptuses (embryo and extraembryonic membranes). Results from our laboratory indicate that arginine (Arg), leucine (Leu), glutamine (Gln), and glucose increase in the uterine lumen between Days 10 and 15 of pregnancy, coincident with increases in expression of amino acid and glucose transporters by uterine epithelia as well as trophectoderm and yolk sac of conceptuses and elongation of the conceptus trophectoderm. Therefore, we hypot

We report on the preparation of transparent oriented titania nanotube (NT) photoelectrodes and the effect of illumination direction on light harvesting, electron transport, and recombination in dye-sensitized solar cells (DSSCs) incorporating these electrodes. High solar conversion efficiency requires that the incident light enters the cell from the photoelectrode side. However, it has been synthetically challenging to prepare transparent TiO(2) NT electrodes by directly anodizing Ti metal films

Various noble metal-free electrocatalysts have been explored to enhance the overall water splitting efficiency. Ni-based compounds have attracted substantial attention for achieving efficient oxygen evolution reaction (OER) and hydrogen evolution reaction (HER) catalysts. Here, we show superior electrocatalysts based on NiFe alloy electroformed by a roll-to-roll process. NiFe (oxy)hydroxide synthesized by an anodization method for the OER catalyst shows an overpotential of 250 mV at 10 mA cm<sup

A silver‐based joining technique referred to as reactive air brazing has been recently developed for joining high‐temperature structural ceramic components of the type used in gas turbines, combustion engines, heat exchangers, and burners. It was found that additions of copper oxide to silver exhibit a tremendous effect on both the wettability and joint strength characteristics of the subsequent braze relative to polycrystalline alumina substrates. The effect is particularly significant at low c