Hong-seok Moon

PURPOSE: This study aimed to determine the most reliable scanning strategy and scanner type, using a new protocol for assessing the accuracy (trueness and precision) of intraoral scan data. MATERIALS AND METHODS: Five different maxillary and mandibular typodont pairs (n = 10) and 2 intraoral scanners were used for the study. A reference scan for each arch was obtained with an industrial scanner. Scanning strategies were classified into 2 continuous methods-continuous scan in horizontal direction

The present study was intended to investigate changes in the microstructure and phase transformation of zirconia surfaces using etching and airborne-particle abrasion (AB) and the effects of these processes on the shear bond strength of dental resin cements to zirconia. Four groups were classified according to the surface treatment as follows: etching for 15 min (ET15), etching for 30 min (ET30), AB, and etching for 15 min following AB (ABET). These groups were then classified into two subgroups

Abstract Purpose To evaluate the accuracy of three digitization methods for the maxillary dental arch. Materials and Methods A maxillary typodont with various tooth preparation designs was used as the reference model. The scanned data were classified into direct scanning (DS), cast scanning (CS), and impression scanning (IS) groups according to the techniques applied for digitization (n = 10/group). An intraoral scanner was used for the DS group. Impressions obtained with polyether impression ma

The purpose of this study was to compare and evaluate, through histomorphometric and radiological analysis, the effects of UV photofunctionalization on an implant placed over a critical defect area with and without a bone graft. Four female beagle dogs were first divided into control and bone graft groups. Each group was then subdivided into UV-treated and UV-untreated groups. The mandibular premolars in each dog were extracted. 12 weeks after extraction, implants were placed according to the co

Abstract The interface between yttrium oxide partially stabilized tetragonal zirconia polycrystalline (Y‐TZP) core and veneering porcelain is the site of most clinical failures. Many efforts have focused on increasing the bond strength between Y‐TZP core and veneering porcelain, and such approaches include increasing the surface roughness and providing undercuts. However, each surface roughening method carries limitations. The specific aim of this study was to test the bond strengths of Y‐TZP su

This study investigates the effect of acid etching treatment on the surface microstructure, surface roughness, and surface contact angle of zirconia and compares the effects of air abrasion, different etching times, and aging on the shear bond strength (SBS) of resin cement on the zirconia surface. 480 specimens (9 × 10 × 10 mm) were divided into as-sintered and air-abraded groups, and each group was further subdivided into six groups based on etching time (0, 3, 5, 10, 20, and 30 min). The etch

In this study, we evaluated the effects of ultraviolet (UV) treatment and alendronate (ALN) immersion on the proliferation and differentiation of MG-63 osteoblast-like cells and human gingival fibroblasts (HGFs) cultured on titanium surfaces. MG-63 cells were used for sandblasted, large grit, and acid-etched (SLA) titanium surfaces, and HGFs were used for machined (MA) titanium surfaces. SLA and MA specimens were subdivided into four groups (n = 12) according to the combination of surface treatm

Limited evidence is available comparing the differences between pre-operative and post-operative 3D implant positions from the viewpoint of prosthetics. We aimed to investigate the differences between preplanned positions of virtual provisional restorations and their actual positions following fully guided single-implant placement. Ten maxillary typodonts with missing right central incisors were imaged using cone-beam computed tomography, and digital impressions were obtained using an intraoral