이선영

Graphitic carbon nitride (g-C3N4) was hybridized with CdS nanoparticles and reduced graphene oxide (RGO) sheets using a facile chemical method, for the application of catalytic photodegradation of Rhodamine B and Congo red dyes under irradiation with UV and visible light. Fourier-transform infrared (FTIR) spectroscopy and X-ray photoemission spectroscopy (XPS) analyses confirmed the formation of pure g-C3N4, as well as g-C3N4/CdS, g-C3N4/RGO, and g-C3N4/CdS/RGO composites. The large surface area

Highly stable plasmonic potocatalysts based on Au, graphitic carbon nitride (g-C₃N₄), and carbon nanotubes (CNTs) hybrids for effective degradation of organic pollutant and photoelectrchemical (PEC) water splitting.

Visible light-active bismuth oxychloride–reduced graphene oxide (BiOCl–RGO) composite photocatalysts were synthesised using a hydrothermal method at low temperature, and at a low cost. This approach reduced the recombination of electron–hole pairs and thereby provided more efficient photocatalysts. The size of BiOCl structure was controlled by polyvinylpyrrolidone (PVP) addition. Furthermore, formation of nanosized BiOCl sheets and BiOCl–RGO composites were confirmed by X-ray diffraction, X-ray

Aligned 1D ZnO/g-C₃N₄ films were fabricated by simple refluxing with thermal vapor condensation for rapid charge separation and recyclable test.

Fabrication of 1-D ZnTiO₃ nanofibers and 2-D g-C₃N₄ based hybrid heterojunctions and their H₂ evolution from water splitting under visible light irradiation.

We engineered high aspect ratio Fe₂O₃ nanorods (with an aspect ratio of 17 : 1) coated with g-C₃N₄ using a sequential solvothermal method at very low temperature followed by a thermal evaporation method. Here, the high aspect ratio Fe₂O₃ nanorods were directly grown onto the FTO substrate under relatively low pressure conditions. The g-C₃N₄ was coated onto a uniform Fe₂O₃ nanorod film as

A thermomechanical writing system and a piezoelectric readback system have been demonstrated using silicon cantilevers integrated with heaters and piezoelectric sensors for a low-power scanning-probe-microscopy data-storage system. A thin polymethylmethacrylate film has been used as a media to record data bits of 50 nm in diameter and 25 nm in depth using the silicon cantilever. The sensitivity of 0.22 fC/nm was also obtained using the fabricated cantilever. Finally, to obtain readback signals u