Jee‐Hwan Kim

The prevalence of the PSAA on CT images was higher, and the diameter was larger in males. The PSAA was more close to the alveolar crest in the molar areas. The evaluation of the PSAA in maxillary sinus on CT images before surgery could reduce the likelihood of excess bleeding during surgery especially in molar areas.

Monolithic CAD/CAM lithium disilicate crowns are applicable to posterior implant-supported restorations because the fracture load was higher than the average occlusal force.

The amount of photopolymer material consumed during the three-dimensional (3D) printing of a dental model varies with the volume and internal structure of the modeling data. This study analyzed how the internal structure and the presence of a cross-arch plate influence the accuracy of a 3D printed dental model. The model was designed with a U-shaped arch and the palate removed (Group U) or a cross-arch plate attached to the palate area (Group P), and the internal structure was divided into five

Body mass index was related to periodontitis, but not to dental caries, suggesting that obesity is a risk factor for periodontitis.

Alendronates seemed to decrease bone resorption but not to decrease bone formation. Empty lacunae were observed significantly more at later time points in implant sites compared to extraction sockets.

Complications associated with the use of bisphosphonate (BP) have risen over the years due to an increase in the prescription of BP. BP-related osteonecrosis of jaw (BRONJ), one of the complications linked to the consumption of BP, greatly affects patients with minor dental trauma, incurring a long healing period. While BRONJ afflicts only a minority of patients prescribed with BP, BRONJ is a multigenic disease affected both by environmental and genetic factors having a distinctive phenotype. Th

Three-dimensional (3D) printing polymers such as urethane dimethacrylate (UDMA) and ethoxylated bisphenol A dimethacrylate (Bis-EMA) are typically used in definitive prosthesis and require surface treatments before bonding. However, surface treatment and adhesion conditions often affect long-term use. Herein, polymers were divided into Groups 1 and 2 for the UDMA and Bis-EMA components, respectively. The shear bond strength (SBS) between two types of 3D printing resins and resin cements was meas

This study evaluated the shear bond strength (SBS) and biaxial flexural strength (BFS) of resin cements according to the surface treatment method using low-temperature hot etching with hydrofluoric acid (HF) on a yttrium-stabilized tetragonal zirconia (Y-TZP) surface; 96 discs and 72 cubes for BFS and SBS tests for Y-TZP were randomly divided into four groups of BFS and three groups of SBS. Specimens were subjected to the following surface treatments: (1) no treatment (C), (2) air abrasion with

To assess the accuracy of various intraoral scanners (IOSs) and to investigate the existence of mutual compatibility that affects the accuracy between IOS and 3-dimensional (3D) printing using a scan quadrant model. For clinical implication, crown preparations and cavity design according to prosthetic diagnosis and treatment considerations must be acquired by a digital scanner. The selected typodont model was scanned using a reference scanner, from which reference (Ref) standard tessellation lan

The patient with minor allele of ss518063493 may be associated with excessive atrophy of edentulous mandible whereas the patients with that of rs840869 are not associated in Korean population. The result from this study may assist in developing a novel genetic diagnostic test and be useful in identifying Koreans susceptible to developing excessive jawbone atrophy after dental extraction.