윤용진

The term "Lab-on-a-Chip," is synonymous with describing microfluidic devices with biomedical applications. Even though microfluidics have been developing rapidly over the past decade, the uptake rate in biological research has been slow. This could be due to the tedious process of fabricating a chip and the absence of a "killer application" that would outperform existing traditional methods. In recent years, three dimensional (3D) printing has been drawing much interest from the research communi

Fabrication of tissue engineering scaffolds with the use of novel 3D printing has gained lot of attention, however systematic investigation of biomaterials for 3D printing have not been widely explored. In this report, well-defined structures of polycaprolactone (PCL) and PCL- carbon nanotube (PCL-CNT) composite scaffolds have been designed and fabricated using a 3D printer. Conditions for 3D printing has been optimized while the effects of varying CNT percentages with PCL matrix on the thermal,

Intracochlear pressure is calculated from a physiologically based, three-dimensional gerbil cochlea model. Olson [J. Acoust. Soc. Am. 103, 3445-3463 (1998); 110, 349-367 (2001)] measured gerbil intracochlear pressure and provided approximations for the following derived quantities: (1) basilar membrane velocity, (2) pressure across the organ of Corti, and (3) partition impedance. The objective of this work is to compare the calculations and measurements for the pressure at points and the derived

The hygroscopic property of particulate matter (PM) influencing light scattering and absorption is vital for determining visibility and accurate sensing of PM using a low-cost sensor. In this study, we examined the hygroscopic properties of coarse PM (CPM) and fine PM (FPM; PM_2.5) and the effects of their interactions with weather factors on visibility. A censored regression model was built to investigate the relationships between CPM and PM_2.5 concentrations and weather ob

Abstract This work describes acylation reactions facilitated by a type of heterocycle‐based acyl transfer agent, 2‐acyloxypyridazinone. Reactions of 2‐acyloxypyridazinone with carboxylic acids yield mixed carbonic anhydride intermediates, which are reactive and could be coupled with a wide range of substrates including acids, amines, alcohols, and thiols. The wide substrate scope, ease of operation (no additive or catalyst), storage and handling stability, and atom‐efficiency from recycling the

The selective syntheses of carbamates, symmetric ­ureas, and unsymmetrical ureas have been accomplished by the ­reaction of amines with phenyl 4,5-dichloro-6-oxopyridazine-1(6H)-carboxylate as a carbonyl source under mild conditions. It is noteworthy that this process is mild, economic, and convenient.