Hugo Rodrigue 교수

The one-dimensional deformation of shape memory alloy (SMA) wires and springs can be implemented into different types of functional structures with three-dimensional deformations. These structures can be classified based on the type of structure and how the SMA element has been implemented into the following categories: rigid mechanical joints, semi-rigid flexural hinges, SMA elements externally attached to a soft structure, and embedded into the soft structure. These structures have a wide rang

A novel linear actuator called origami-based vacuum pneumatic artificial muscle (OV-PAM) is proposed in this study that can produce large forces (>400 N) with a contraction ratio >90% of the active length of the actuator. Moreover, some of the designs presented in this article can lift large loads with large contraction ratios at extremely low vacuum pressure (≈10 kPa). This actuator consists of a sealed origami film chamber connecting a polygonal top and bottom plate with evenly spaced transver

A new manufacturing method for smart soft composite (SSC) actuators that consists of double casting a SSC actuator to produce an actuator with non-linear shape memory alloy (SMA) wire positioning is proposed. This method is used to manufacture a tube-shaped SSC actuator in which the SMA wires follow the curvature of the tube and is capable of pure-twisting deformations while sustaining a cantilever load. The concept is tested by measuring the maximum twisting angle and a simple control method is

This paper introduces the addition of torsional prestrain into the manufacturing process of shape memory alloy (SMA) springs to form torsionally prestrained SMA springs. These springs have a better performance at the same power input for the same loads and same coil dimensions as regular SMA springs. A modified thermoconstitutive model was presented that can predict the behavior of the actuator based on the amount of torsional prestrain added into the manufacturing process, and a simple two-stat

Abstract The performance of soft linear actuators will determine the capabilities of future soft robots, and any actuator that can produce larger deformations and forces with a low weight and using lower pressures could potentially become ubiquitous in the field. In this work, the design of paired pouch motors that can produce a maximum contraction ratio of 41.9% and of 31% with a 10 kg payload is presented. The design of higher‐order pairings of pouch motors is demonstrated to produce even larg

Most soft pneumatic actuators for producing bending actuation have made use of either positive or negative pressure and adjusted their design in consequence. In the proposed paper, a novel soft bending actuator using combined positive and negative pressures (PNP) where the bending force of a negative pressure actuator and a positive pressure actuator is combined into a single actuating structure. This actuator is capable of producing a blocked force as high as 150 N at a combined positive pressu

This article introduces a novel design for a soft morphing actuator capable of pure twisting motion through a pair of shape memory alloy wires embedded in a polydimethylsiloxane matrix at constant and opposite eccentricity across the cross section in opposite directions. This report introduces the design of the actuator, the manufacturing method, and experimental results for the twisting angle and twisting force when varying the dimensions of the matrix of the actuator. Afterward, a simple model

Abstract Shape memory alloy (SMA)-based soft actuators and grippers have generally used SMA wires due to design restrictions, limited actuation force and poor cooling performance of SMA springs. This work demonstrates that SMA springs can be used for high performance soft actuation by positioning them externally as a tendon with the force transmitted to the polymeric matrix using a tendon. Through improvements by using active cooling through fans, a spring longer than the matrix and a matrix wit