정현도 교수

Chronic wounds in diabetic patients are challenging because their prolonged inflammation makes healing difficult, thus burdening patients, society, and health care systems. Customized dressing materials are needed to effectively treat such wounds that vary in shape and depth. The continuous development of 3D-printing technology along with artificial intelligence has increased the precision, versatility, and compatibility of various materials, thus providing the considerable potential to meet the

Poly(ether imide) (PEI) has shown satisfactory corrosion protection capability with good adhesion strength as a coating for magnesium (Mg), a potential candidate of biodegradable orthopedic implant material. However, its innate hydrophobic property causes insufficient osteoblast affinity and a lack of osseointegration. Herein, we modify the physical and chemical properties of a PEI-coated Mg implant. A plasma immersion ion implantation technique is combined with direct current (DC) magnetron spu

Magnesium (Mg) and its alloys are promising materials for biodegradable drug-eluting stent applications, but their rapid corrosion remains a major challenge for clinical practice. Considerable efforts have been made to develop an efficient surface coating that can provide higher Mg stent corrosion resistance, sustained drug-delivery capability, and vascular compatibility. Herein, we introduce poly(ether imide) (PEI) and poly(lactic-co-glycolic acid) (PLGA) as surface coating polymers for WE43 Mg

Polyetheretherketone (PEEK), one of the potential alternatives to metallic materials for implants, necessarily involves high temperature process conditions to be three-dimensionally (3D) printed. We developed a 3D printing setup equipped with thermally stabilized modules of the printing nozzle and building chamber, by which the PEEK implants could be successfully manufactured. Under optimized printing conditions, the maximal mechanical strength of the 3D printed sample attained over 80% of the o

Abstract Orthopedic implants should have sufficient strength and promote bone tissue regeneration. However, most conventional implants are optimized for use either under high mechanical load or for active osseointegration. To achieve the dual target of mechanical durability and biocompatibility, polyether ether ketone (PEEK) filaments reinforced with internal titanium dioxide (TiO 2 ) nanoparticles via dopamine‐induced polymerization are additively manufactured into an orthopedic implant through

Biodegradable stents made of magnesium (Mg) and its alloys have been developed to minimize persistent inflammation or in-stent restenosis, which are the main problems for permanent stents. However, their rapid corrosion behavior under physiological conditions leads to poor vascular compatibility and premature structural failure, which remains an important unsolved clinical problem. Herein, we demonstrate a new strategy for solving this problem by combining poly (ether imide) (PEI) coating and su

Porous hydroxyapatite (HA) scaffolds with porosity-graded structures were fabricated by sequential freeze-casting. The pore structures, compressive strengths, and biocompatibilities of the fabricated porous HA scaffolds were evaluated. The porosities of the inner and outer layers of the graded HA scaffolds were controlled by adjusting the initial HA contents of the casting slurries. The interface between the dense and porous parts was compact and tightly adherent. The porosity and compressive st