Takayuki Nagata 교수

In this study, analysis of flow properties around a sphere and its aerodynamic coefficients in the high-Mach-and-low-Reynolds-numbers conditions is carried out by direct numerical simulations solving the three-dimensional compressible Navier–Stokes equations. The calculation is performed on a boundary-fitted coordinate system with a high-order scheme of sufficient accuracy. The analysis is conducted by assuming a rigid sphere with a Reynolds number of between 50 and 300, based on the diameter of

In the present study, compressible low-Reynolds-number flow past a stationary isolated sphere was investigated by direct numerical simulations of the Navier–Stokes equations using a body-fitted grid with high-order schemes. The Reynolds number based on free-stream quantities and the diameter of the sphere was set to be between 250 and 1000, and the free-stream Mach number was set to be between 0.3 and 2.0. As a result, it was clarified that the wake of the sphere is significantly stabilized as t

The present study proposes a sensor selection method based on the proximal splitting algorithm and the A-optimal design of experiment using the alternating direction method of multipliers (ADMM) algorithm. The performance of the proposed method was evaluated with a random sensor problem and compared with previously proposed methods, such as the greedy and convex relaxation methods. The performance of the proposed method is better than the existing greedy and convex relaxation methods in terms of

In this study, an analysis of the flow properties around an isolated sphere under isothermal conditions for flows with high Mach numbers and low Reynolds numbers is conducted via direct numerical simulation (DNS) of the three-dimensional compressible Navier–Stokes equations. The calculations are performed with a boundary-fitted coordinate system. The Reynolds number based on the diameter of the sphere and the freestream quantities is varied from 100 to 300, the freestream Mach number is varied b

Abstract Sweet potato starches extracted from two varieties at different stages of development were investigated for various physicochemical properties. Average granule size increased in the early stage of development. The amylose content calculated from the blue value (BV) remained almost constant. The onset temperature (To) determined by differential scanning calorimetry (DSC) was lowest in the latest stage of development. The heat of gelatinization (ΔH) was lowest in the earliest stage of dev

Abstract Sweet potato starches prepared from the peel ( P ), cambium ( C ), and inner‐tissue ( IT ) were tested for physicochemical properties. The average granule sizes of the IT starches were tended to be larger than those of the P and C starches. Amylose contents of starches from the different tissue zones did not differ significantly. The onset and peak temperatures ( T o , T p ) of the P starches determined by differential scanning calorimetry (DSC) were somewhat high. The C starches were r

The present paper proposes a data-driven sensor selection method for a high-dimensional nondynamical system with strongly correlated measurement noise. The proposed method is based on proximal optimization and determines sensor locations by minimizing the trace of the inverse of the Fisher information matrix under a block-sparsity hard constraint. The proposed method can avoid the difficulty of sensor selection with strongly correlated measurement noise, in which the possible sensor locations mu

SUMMARY Reconstruction of the distribution of ground motion due to an earthquake is one of the key technologies for the prediction of seismic damage to infrastructure. Particularly, the immediate reconstruction of the spatially continuous wavefield is valuable for decision-making of disaster response decisions in the initial phase. For a fast and accurate reconstruction, utilization of prior information is essential. In fluid mechanics, full-state recovery, which recovers the full state from spa

In this study, direct numerical simulation of the flow around a rotating sphere at high Mach and low Reynolds numbers is conducted to investigate the effects of rotation rate and Mach number upon aerodynamic force coefficients and wake structures. The simulation is carried out by solving the three-dimensional compressible Navier–Stokes equations. A free-stream Reynolds number (based on the free-stream velocity, density and viscosity coefficient and the diameter of the sphere) is set to be betwee

Abstract In the present study, new performance evaluation parameters for pressure-sensitive paint (PSP) were proposed, and the effects of ambient pressure on the characteristics of the PSP were evaluated. The proposed parameters allow us to determine the optimal pressure range on the basis of the following quantities: (1) the Stern–Volmer coefficient, (2) the normalized pressure sensitivity to intensity changes due to flow-induced pressure fluctuations, (3) the change in the intensity of PSP emi

The randomized group-greedy (RGG) method and its customized method for large-scale sensor selection problems are proposed. The randomized greedy sensor selection algorithm is applied straightforwardly to the group-greedy (GG) method, and a customized method is also considered. In the customized method, a part of the compressed sensor candidates is selected using the common greedy method or other low-cost methods. This strategy compensates for the deterioration of the solution due to compressed s

Summary In the present study, we proposed a simple collision algorithm, which can be handled arbitrarily shaped objects, for flow solvers using the immersed boundary method (IBM) based on the level set and ghost cell methods. The proposed algorithm can handle the collision of the arbitrarily shaped object with little additional computational costs for the collision calculation because collision detection and calculation are performed using the level set function and image point, which are incorp