장봉순 교수

e analysed the CT scans and radiographs of 76 vertebrae in 49 patients who underwent vertebroplasty for painful osteoporotic compression fractures. Leaks of cement were classified into three types: those via the basivertebral vein (type B), via the segmental vein (type S), and through a cortical defect (type C). More leaks were identified on CT scans than on radiographs by a factor of 1.5 (74/49). Most type-B (93%) and type-S (86%) leaks were missed or underestimated on a lateral radiograph whic

Robotic-assisted pedicle screw placement was associated with fewer proximal facet joint violations and better convergence orientations.

Anterior cervical fusion using a stand-alone cage with a large AP diameter while preventing anterior intraoperative over-distraction will be helpful to prevent the subsidence of cages. Two-level cervical fusion might require more careful attention for avoiding nonunion.

The ratio of fused area of local bone inside cages at regions exposed to endplates was <50%, which is insufficient for physiologic load transmission. The authors recommend that additional bone should be grafted into the disc space or new bone bonding interbody spacer should be considered.

Although vertebral artery groove and foramen violations were relatively common on postoperative CT scans, none were detected intraoperatively or on postoperative radiographs. Most alarmingly, 1 vertebral artery injury was undetected intraoperatively. Since a vertebral injury can be potentially catastrophic, this study emphasizes the inherent dangers associated with placement of C1 and C2 screws and underscores the importance of careful postoperative evaluation and surgical technique when inserti

The accuracy of diagnostic lumbar selective nerve root blocks is only moderate. To improve the accuracy, great care should be taken to avoid inadequate blocks and overflow, and to precisely interpret spot radiographs.

To evaluate the possibility of novel CaO-SiO2-B2O3 glass-ceramics (CS10B) as a new bone replacement material, we compared the biodegradation and osteoconduction properties of CS10B, hydroxyapatite (HA), and tricalcium phosphate (TCP). Porous CS10B implants were prepared by the polymer sponge method. L5-6 single-level posterolateral spinal fusions were performed on 30 New Zealand white male rabbits. The animals were divided into three groups by implant material: CS10B, HA, and TCP. Radiographs we

Patients' satisfaction was not as high as expected after fusion for LDD. Therefore, the decision for performing a lumbar fusion in those patients must be done more carefully, and it should be explained more precisely that chronic pain may persist after spinal surgery.

The 4-year follow-up study showed similar fusion rates and clinical outcomes in both the BGS-7 spacer and autologous bone with a titanium cage in 1-level PLIF. However, the BGS-7 spacer implants showed a larger area of fusion with the endplates than that of autologous bone with a titanium cage. Therefore, the results demonstrated that the BGS-7 spacer can be considered as a novel intervertebral spacer to achieve successful spinal fusion without safety concerns for long-term use.

Screw placement is feasible in up to 93% of the occipital condyles. The lateral and the middle entry points are significantly better than the medial entry point. Selection between the middle and the lateral entry points should be individualized taking into account local anatomic variation. Because the medial angulation of these screws is highly variable, preoperative 3-dimensional CT evaluation and possibly even intraoperative navigation may be required.

This is the first study to describe the sagittal alignment in patients with TOLF. The TOLF group showed a hypolordotic spine with a larger PI-LL mismatch compared to the age- and sex-matched control group with lumbar spondylosis.Level of Evidence: 4.