Skip to main content

심형섭 교수

Hyungsub Sim

KAIST 항공우주공학과 · 공학

연구실 소개

심형섭 교수의 연구실은 연소 과정에서의 열역학적 및 유동적 상호작용을 고속 이미징 및 정밀 측정 기법을 통해 분석하는 데 중점을 두고 있습니다. 특히, 고압 연소 플레어, 나노입자 첨가 연소, 음향장 영향 하에서의 화염 안정성 및 연소 동역학을 실험적·수치적 방법으로 연구하고 있습니다. 또한, 나노소재와 촉매를 활용한 고온 고압 조건에서의 연료 분해 및 에너지 변환 메커니즘을 규명하고 있습니다. 이는 고성능 연료 개발 및 청정 연소 기술의 핵심 기초 연구입니다.

고속 이미징나노입자 첨가음향-화염 상호작용연소 동역학촉매 연료 분해

연구 현황

논문 수
73
총 인용 수
466
최근 5년 논문
43
주요 분야
공학

연구 성과 추이

표시된 성과는 수집된 데이터 기준으로 산출되며, 일부 차이가 있을 수 있습니다.

5개년 연도별 논문 게재 수
43총합
2022
2023
2024
2025
2026
5개년 연도별 피인용 수
134총합
20222023202420252026

주요 논문

15
1
논문|인용수 50·2020
Detailed measurements of transient two-stage ignition and combustion processes in high-pressure spray flames using simultaneous high-speed formaldehyde PLIF and schlieren imaging
Hyung Sub Sim, Noud Maes, Lukas Weiß, Lyle M. Pickett, Scott A. Skeen
SJR Q1Proceedings of the Combustion InstituteOA

This study investigates the low- and high-temperature ignition and combustion processes in a high-pressure spray flame of n-dodecane using simultaneous 50-kHz formaldehyde (HCHO) planar laser-induced fluorescence (PLIF) and 100-kHz schlieren imaging. The PLIF measurements were facilitated through the use of a pulse-burst-mode Nd:YAG laser, producing a 355-nm pulse-train with 300 pulses at 70 mJ/pulse, separated by 20-µs, in a 6-ms burst. The high-speed HCHO PLIF signal was imaged using a non-int

Fluid Flow and Transfer ProcessesChemical Engineering
2
논문|인용수 28·2020
Laminar Microjet Diffusion Flame Response to Transverse Acoustic Excitation
Hyung Sub Sim, Andres Vargas, Dongchan Daniel Ahn, Ann Karagozian
SJR Q2Combustion Science and Technology

The present experiments focused on the response of burning gaseous fuel jets to prescribed transverse acoustic excitation as a means of exploring the coupling of reactive, acoustic, and flow processes relevant to combustion instabilities. Single reactive methane microjets were exposed to transverse resonant standing wave disturbances within an acoustic waveguide for which a range of amplitudes of excitation were applied. Temporal flame response to acoustic excitation was studied via simultaneous

Computational MechanicsEngineering
3
논문|인용수 25·2020
Functionalized graphene sheet as a dispersible fuel additive for catalytic decomposition of methylcyclohexane
Hyung Sub Sim, Richard A. Yetter, Sungwook Hong, Adri C. T. van Duin, Daniel M. Dabbs, İlhan A. Aksay
SJR Q1Combustion and FlameOA
Computational MechanicsEngineering
4
논문|인용수 24·2018
Effects of Inert and Energetic Nanoparticles on Burning Liquid Ethanol Droplets
Hyung Sub Sim, Miguel A. Plascencia, Andres Vargas, John W. Bennewitz, Owen I. Smith, Ann Karagozian
SJR Q2Combustion Science and Technology

The effect of nanoscale energetic aluminum (nAl) and inert silicon dioxide (nSiO2) particulate additives on ethanol droplet combustion was studied under atmospheric conditions. Three different types of droplet experiments were performed to study the influence of the experiment itself on combustion behavior. Simultaneous visible and intensified ultraviolet (UV) images were taken to determine the burning rate constant (K) as well as flame dynamics via OH* chemiluminescence imaging. The addition of

Mechanics of MaterialsEngineering
5
논문|인용수 23·2008
Femtosecond pulse laser interactions with thin silicon films and crater formation considering optical phonons and wave interference
Hyung Sub Sim, Seong Hyuk Lee, Kwan Gu Kang
SJR Q3Microsystem Technologies
Computational MechanicsEngineering
6
논문|인용수 23·2019
Acoustically Forced Droplet Combustion of Liquid Fuel with Reactive Aluminum Nanoparticulates
Hyung Sub Sim, Miguel A. Plascencia, Andres Vargas, Ann Karagozian
SJR Q2Combustion Science and Technology

This experimental study explores the effects of acoustic excitation on burning droplets of liquid ethanol loaded with reactive aluminum nanoparticles (nAl). Continuously fed fuel droplet combustion and flame extinction (blowout) experiments were conducted in the vicinity of a pressure node (or velocity antinode) created in a closed acoustic waveguide, with a range of applied resonant forcing frequencies, pressure or velocity perturbation amplitudes, and particle loading concentrations. Simultane

Computational MechanicsEngineering
7
논문|인용수 21·2010
Femtosecond Laser Pulse Train Effect on Optical Characteristics and Nonequilibrium Heat Transfer in Thin Metal Films
Hyung Sub Sim, Seung Ho Park, Tae-Hyoung Kim, Young Ki Choi, Joon Sik Lee, Seong Hyuk Lee
SJR Q2MATERIALS TRANSACTIONSOA

The objective of this study is to numerically investigate the electron-phonon interactions and the nonequilibrium energy transfer in metal thin films irradiated by ultrashort pulse train lasers. In particular, the temporal and spatial variations in the optical properties during laser irradiation are discussed; the influence of the number of pulses per train and the pulse separation time are also examined. The present study uses the well-established two-temperature model to describe laser-solid i

Computational MechanicsEngineering
8
논문|인용수 20·2020
Enhanced Fuel Decomposition in the Presence of Colloidal Functionalized Graphene Sheet-Supported Platinum Nanoparticles
Hyung Sub Sim, Richard A. Yetter, Sungwook Hong, Adri C. T. van Duin, Daniel M. Dabbs, İlhan A. Aksay
SJR Q1ACS Applied Energy Materials

Experiments and simulations were used to demonstrate that decorating functionalized graphene sheets (FGSs) with platinum nanoparticles (Pt@FGS) stabilized these particles. Addition of these particles to liquid hydrocarbon fuels was observed to significantly affect decomposition under supercritical conditions at a pressure of 4.75 MPa and temperatures from 753 to 803 K. The suspension of only 50 ppmw Pt@FGS in the fuel (equivalent to adding 10 ppmw Pt) enhanced fuel conversion rates (by up to 24%

Materials ChemistryMaterials Science
9
논문|인용수 15·2020
Multifunctional Graphene-Based Additives for Enhanced Combustion of Cracked Hydrocarbon Fuels under Supercritical Conditions
Hyung Sub Sim, Richard A. Yetter, Terrence L. Connell, Daniel M. Dabbs, İlhan A. Aksay
SJR Q2Combustion Science and Technology

As a particulate fuel additive, functionalized graphene sheets (FGS), with and without the decoration of nanoparticles, provide a means to form stable colloids with liquid hydrocarbons, act as in situ catalysts, and prevent attached nanoparticles from agglomerating or sintering during heating. Recent pyrolysis experiments and simulations have shown the synergetic effect of Pt and FGS structures accelerating fuel conversion and hydrogen formation. In this paper, the role of graphene-based additiv

Biomedical EngineeringEngineering
10
논문|인용수 15·2023
High-speed formaldehyde planar laser-induced fluorescence and schlieren to assess influences of injection pressure and oxygen concentration on Spray A flames
Hyung Sub Sim, Noud Maes, Lyle M. Pickett, Scott A. Skeen, Julien Manin
SJR Q1Combustion and FlameOA
Fluid Flow and Transfer ProcessesChemical Engineering
12
논문|인용수 9·2024
Injection rate measurements and Machine-Learning based predictions of ECN Spray A-3 piezoelectric injector
Eungyo Choi, J H Park, Joonsik Hwang, H. William Oh, Julien Manin, Hyung Sub Sim
SJR Q1Applied Thermal Engineering
Civil and Structural EngineeringEngineering
13
논문|인용수 6·2008
Numerical Investigation of Opto-Energy Phenomena in Thin Gold Films Irradiated by Femtosecond Pulse Laser Considering Quantum Effects
Hyung Sub Sim, Seong Hyuk Lee
SJR Q2Numerical Heat Transfer Part A Applications

Nonequilibrium energy transport and optical characteristics in thin gold film structures irradiated by a femtosecond pulse laser are examined numerically. With the use of a two-temperature model, the quantum effect is considered to determine various thermo-optical properties such as electron heat capacity, electron thermal conductivity, collision frequencies, reflectivity, and absorption rates. As a result, estimation on the electron temperature considering the quantum effect is in better agreem

Computational MechanicsEngineering
14
논문|인용수 6·2007
Numerical analysis of crater formation and ablation depth in thin silicon films heated by ultrashort pulse train lasers
Hyung Sub Sim, Seong Hyuk Lee, Joon Sik Lee
SJR Q2Journal of Mechanical Science and Technology
Computational MechanicsEngineering
15
논문|인용수 4·2023
Sintering and oxidation characteristics of aluminum nanoparticles coated with hydrocarbons: A ReaxFF molecular dynamics simulation study
S.-J. Kim, Chang‐Min Yoon, Hyung Sub Sim, Sungwook Hong
SJR Q2Physics Letters AOA

Aluminum nanoparticles (ANPs) have attracted significant attention for combustion applications owing to their high energy density and reactivity. Surface coating has been proposed to overcome the limitations of ANPs, which are sintering and oxidizing at moderate temperatures; however, the thermal behavior of surface-coated ANPs remains unclear. In this study, reactive molecular dynamics simulations of ANP sintering and oxidation were performed to investigate the effectiveness of hydrocarbon surf

Mechanics of MaterialsEngineering

대표 연구 분야

Computational MechanicsFluid Flow and Transfer ProcessesMechanics of MaterialsBiomedical EngineeringCeramics and CompositesMaterials Chemistry

심형섭 교수의 연구를 Nubint에서 더 깊이 살펴보세요

이 연구실의 논문을 앱에서 열어 AI와 함께 읽고, 핵심을 요약하고, 내 글에 인용하세요.